Clutch Release Bearing Replacement

Clutch Release Bearing Replacement

Removal Procedure

1. Remove the transmission. Refer to Transmission Replacement Transmission Replacement.





2. Remove pressure line fastening sleeve (1).

* Unlatch fastening sleeve for pressure line on clutch housing (arrows).

* Draw fastening sleeve out of transmission slightly.

* Detach fastening sleeve for pressure line.

* Carefully unlatch 2x retaining lug (3).





3. Remove central release (1) with hydraulic line.

Remove 3x fasteners (arrow).

Installation Procedure





1. Clean 3x thread (1) in transmission.

Note:
Note installation position.

2. Install fastening sleeve for pressure line.





Note:

* Use new bolts.

* It is essential to avoid pulling the central release at an angle.

3. Install central release (1) with hydraulic line.

* Clip hydraulic line in sleeve.

* Lightly coat seal ring in central release with transmission fluid.

* Preassemble 3 fasteners evenly in contact with the flange.

* Tighten the 3 fasteners from central release (arrow) to 6 Nm (53.1 lb in).

4. Install the transmission. Refer to Transmission Replacement Transmission Replacement.