63. Fuel Rail and Injectors Installation

Fuel Rail and Injectors Installation

Special Tools

EN-47909 - Injector Bore and Sleeve Cleaning Kit

For equivalent regional tools, refer to Special Tools Special Tools.





1. Clean the fuel injector bore in the cylinder head using the EN-47909 - kit.

2. Install the fuel rail (1) with injectors into the cylinder head evenly.

3. Hand tighten the 2 outer fuel rail bolts to seat the injector into the injector bores.

Caution:
Refer to Fastener Caution Fastener Caution.

4. Start and hand tighten the remaining fuel rail bolts. Tighten the bolts in sequence to final torque using the following procedure:

1. Tighten first pass in sequence to 25 Nm (18 lb ft).

2. Tighten final pass in sequence to 25 Nm (18 lb ft).

5. Connect the electrical harness to the fuel rail harness connections.





6. Install the fuel injection fuel rail noise shield (1).