C0276

DTC C0275 or C0276





Circuit Description
The YSC relay supplies battery voltage to 4 valve solenoids (priming, charging, supply and YSC). The EBCM microprocessor applies the grounds needed in order to activate each solenoid. The low side of each solenoid coil has a feedback circuit to the EBCM microprocessor. When a solenoid is commanded OFF, the feedback voltage is high. When a solenoid is commanded ON, the feedback voltage is low.

Conditions for Running the DTC
^ The ignition is ON.
^ The vehicle speed is greater than 6 km/h (4 mph).

Conditions for Setting the DTC
The EBCM detects an internal malfunction.

Action Taken When the DTC Sets
^ The EBCM disables the VSES.
^ The message center displays the SERVICE STABILITY SYSTEM message.

Conditions for Clearing the DTC
The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.

Diagnostic Aids
An intermittent open/shorted relay DTC can be set by several different internal EBCM problems. Replace the EBCM if an open/shorted relay DTC continues to set intermittently