Power Accessory Outlet Cover Replacement - Floor Console

REMOVAL PROCEDURE




1. Remove the floor console bezel.
2. Remove the storage bin.
3. Remove the floor console end panel.

IMPORTANT: Do not disconnect the electrical connectors.

4. Separate the end panel from the console in order to gain access to the retaining screws.
5. Remove the 2 screws (1) retaining the power outlet cover to the console end panel.
6. Remove the cover from the end panel.

INSTALLATION PROCEDURE




1. Install the power outlet cover to the end panel.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the 2 retaining screws (1).

Tighten
Tighten the screws to 1.6 N.m (14 lb in).

3. Install the console end panel.
4. Install the storage bin.
5. Install the console bezel.