Seat Replacement - Rear (60/40 Split)

Seat Replacement - Rear (60/40 Split)

Removal Procedure

1. Remove the front and the rear leg trim covers.
2. Remove the seat back recliner handle screw from the trim panel, if equipped.
3. Remove the jack assembly, if required.
4. Remove the covers in order to access the seat bolts.
5. Disconnect the electrical connectors, if equipped.
6. Remove the seat retaining bolts.




7. Remove the seat from the vehicle.

Installation Procedure




1. Install the seat into the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the seat retaining bolts.

Tighten the bolts to 55 N.m (41 lb ft).

3. Connect the electrical connectors, if equipped.
4. Install the jack assembly, if removed.
5. Install the covers to the seat bolts.
6. Install the seat back recliner handle screw, if removed.

Tighten the screw to 2 N.m (18 lb in).

7. Install the front and the rear leg trim covers.