Weatherstrip Replacement - Rear Door - 2

TOOLS REQUIRED
J 38778 Door Trim Pad Clip Remover

REMOVAL PROCEDURE




1. Open the door.
2. Using the J 38778, remove the weatherstrip from the mounting surface.

INSTALLATION PROCEDURE

IMPORTANT: Apply the weatherstrip in an environment that is free from dust or dirt that could come into contact with the adhesive backing. Foreign material may cause improper adhesion.




1. Install the weatherstrip to the mounting surface by completing the following steps:
1.1. Peel off the backing paper.
1.2. Press the retainers into place.
2. Close the door.