Exhaust Heat Shield Replacement Dash Panel
Exhaust Heat Shield Replacement Dash PanelRemoval Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the engine shield bolts and shield, if necessary.
3. Remove the exhaust heat shield nuts.
4. Remove the exhaust heat shield (1, 3) from the dash panel studs.
Installation Procedure
1. Install the exhaust heat shield (1, 3) to the dash panel studs.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the exhaust heat shield nuts.
- Tighten the nuts to 9 Nm (80 inch lbs.).
3. Install the engine shield and bolts, it necessary.
- Tighten the bolts to 20 Nm (15 ft. lbs.).
4. Lower the vehicle.