Headlamp: Service and Repair
REMOVAL PROCEDURECAUTION: Refer to Halogen Bulb Caution in Service Precautions.
NOTE: Refer to Avoid Touching the Bulb in Service Precautions.
1. Remove the front grille.
2. Remove the headlamp retainer pins.
3. Pull out the headlamp assembly in order to access the electrical connector.
4. Disconnect the electrical connector.
5. Remove the rubber cup to gain access the headlamp bulbs.
6. Remove the bulbs.
INSTALLATION PROCEDURE
IMPORTANT:
^ Replace a high beam bulb with another high beam bulb. The high beam bulb has a red gasket.
^ Replace a low beam bulb with another low beam bulb. The low beam bulb has a gray tip and a yellow gasket at the base.
1. install the bulbs.
2. Install the rubber cup.
3. Connect the electrical connector to the lamp assembly.
4. Install the lamp assembly to the vehicle.
5. Install the headlamp assembly retainer pins.
6. Install the front grille.