Body Wiring Harness Junction Block Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable(s).
2. Remove the harness from the front of the body wiring harness junction block.
3. Unsnap the cover from the body wiring harness junction block.




4. Unsnap the top pivots and rotate the body wiring harness junction block (1) down. Unsnap the lower pivots and remove the body wiring harness junction block from the bracket (2).
5. Disconnect the two 68-way IP connectors.
6. Disconnect the remaining wiring connectors from the body wiring harness junction block.
7. Remove the body wiring harness junction block from the vehicle.

INSTALLATION PROCEDURE




1. Connect the two 68-way IP connectors to the body wiring harness junction block.
2. Connect all remaining wiring connectors.
3. Snap the body wiring harness junction block (1) onto the bracket (2).
4. Connect the harness to the front of the body wiring harness junction block.




5. Fasten the cover to the body wiring harness junction block.
6. Connect the negative battery cable(s).