Ignition Relay Diagnosis

CIRCUIT DESCRIPTION
The ignition relay supplies battery positive voltage to the following components:
^ The fuel injectors
^ The ignition coils
^ The powertrain control module (PCM)
^ The throttle actuator control (TAC) module

DIAGNOSTIC AIDS
The following will occur if the ignition relay fails to close:
^ The engine cranks, but does not run.
^ Scan tool data will be available.
^ Instrument panel lights will illuminate.

TEST DESCRIPTION

Steps 1-5:

Steps 6-11:

The numbers below refer to the step numbers on the diagnostic table.
2. This step is testing the battery positive voltage circuit of the ignition relay.
3. This step is testing the ignition 1 positive voltage circuit of the ignition relay.
4. This step is testing the coil ground circuit of the ignition relay.
5. This step isolates the circuits from the ignition relay. All of the circuits at the relay are good if the test lamp illuminates.