Side Impact Inflator Module - Front
REMOVAL PROCEDURECAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the front seat.
3. Remove the seat back cover.
4. Remove the retaining bolts (3) that attach the inflatable restraint side impact module (1) to the seat frame.
5. Remove the inflatable restraint side impact module retainer.
6. Remove the inflatable restraint side impact module wiring harness retaining clips from the seat frame (3).
IMPORTANT: Note the routing of the inflatable restraint side impact module wiring harness (2) and retaining clips within the seat frame (3). It is crucial that the wiring harness (2) be routed the exact same way as from the factory to eliminate the possibility of any cutting or chafing of the wiring harness.
7. Remove the inflatable restraint side impact module wiring harness (2) from the seat frame (3).
8. Remove the inflatable restraint side impact module (1) from the seat frame (3).
INSTALLATION PROCEDURE
1. Install the inflatable restraint side impact module wiring harness (2) to the seat frame (3) while guiding the wiring harness (2) through the appropriate spots on the seat frame (3).
2. Install the inflatable restraint side impact module wiring harness retaining clips to the seat frame.
3. Install the inflatable restraint side impact module (1) to the seat frame.
4. Install the inflatable restraint side impact module retainer.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the inflatable restraint side impact module retaining bolts (3).
Tighten
Use only hand tools to tighten the fasteners to 10 Nm (89 lb in).
6. Install the seat back cover.
7. Install the front seat.
8. Enable the SIR system.