Electronic Column Lock Module

Electronic Column Lock Module Replacement (Column Shift)

- Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42759 Ignition Switch Connector Release Tool
- J 42137 Cam Orientation Plate Adapter

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.

Important: Remove the SIR coil from the steering shaft and let the SIR coil hang freely.

2. Remove the SIR coil.
3. Install the J 23653-SIR and J 42137 to the steering shaft and compress the shaft lock shield.
4. Remove the lock shield retainer from the steering column shaft.
5. Remove the J 23653-SIR and J 42137 from the steering shaft.





6. Remove the following parts from the steering shaft:
6.1. The shaft lock shield (4)
6.2. The turn signal cancel cam (3)
7. Rotate the steering column lock cylinder to the OFF-LOCK position.





8. Insert a small screwdriver into the slot on the electronic lock module and push down on the park lock cable locking tab. Remove park lock cable (1) from the electronic lock module.





9. Rotate the key alarm switch connector from the electronic lock module.
10. Disconnect the passlock electrical connector from the electronic lock module.





11. Remove the ignition lock cylinder.
12. Disconnect the ignition switch (2) from the electronic lock module using the J42759.
13. Remove the ignition switch (2) from the electronic lock module (2).
14. Let the ignition switch (2) hang freely.





15. Remove the electronic lock module (1) mounting screws (2).
16. Remove the electronic lock module (1) from the steering column housing.

Installation Procedure





1. Install the electronic lock module (1) to the steering column housing.
2. Install the electronic lock module (1) mounting screws (2).





3. Install the ignition switch (2) to the electronic lock module (2).
4. Install the ignition lock cylinder.





5. Connect the passlock electrical connector from the lock module
6. Rotate the key alarm switch connector (1) to the electronic lock module.





7. Install park lock cable (1) to the electronic lock module.





8. Install the following parts to the steering shaft:
8.1. The turn signal cancel cam (3)
8.2. The shaft lock shield (4)





9. Install the J 23653-SIR and J 42137 to the steering shaft and compress the shaft lock shield.
10. Install the lock shield retainer to the steering column shaft.
11. Remove the J 23653-SIR and J 42137 from the steering shaft.
12. Install the SIR coil.
13. Enable the SIR system.