Horn Switch

Horn Switch Replacement - On Vehicle

Removal Procedure

Caution: Refer to Servicing the SIR System Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the Inflatable Restraint Steering Wheel module.
3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.





4. Disconnect the horn contact plate (2) captured screws (1,4) from the steering wheel (3).
5. Remove the horn switch (2) from the steering wheel (3).

Installation Procedure





1. Install the horn switch (2) to the steering wheel (3).

Notice: Refer to Fastener Notice in Service Precautions.

2. Connect the horn contact plate (2) captured screws (1,4) to the steering wheel (3).
- Tighten the horn contact plate captured screws to 5.5 Nm (50 inch lbs.).





3. Install the horn plunger to the steering column.
4. Install the inflator module.
5. Enable the SIR system.