Ignition & Key Alarm Switch - Assemble

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle
- Tools Required
- J 42759 Ignition Switch Connector Release Tool





1. Insert J 42759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2) in.





2. Push the key alarm connector (1) into the electronic lock module assembly (2).
3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
4. Install the passkey connector into the electronic lock module assembly (2).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.





6. Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.
7. Install the upper and lower trim covers.
8. Enable the inflatable restraint steering wheel module.