Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble

Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle

- Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Cam Orientation Plate Adapter





1. Install the following parts onto the steering shaft assembly:
1.1. The thrust washer (1).
1.2. The upper bearing spring (2).
2. Lubricate the turn signal cancel cam assembly (3) with lithium grease.
3. Install the turn signal cancel cam assembly (3) onto the steering shaft assembly.
4. Install the cam orientation plate (4) onto the steering shaft assembly.





5. Install the new bearing retainer onto the steering shaft assembly.
6. Compress the cam orientation plate using J 23653-SIR and J 42137.
7. Firmly seat the bearing retainer into the groove on the steering shaft assembly.
8. Remove J 23653-SIR.
9. Install the inflatable restraint steering wheel module coil.
10. Enable the inflatable restraint steering wheel module.