10.5 Inch Axle

Locking Differential Assemble (10.5 Inch Axle)





1. Install the right thrust washer.
2. Install the right cam unit.
3. Install the following parts:
^ The reaction blocks
^ The reaction block thrust washer
^ The pinion yoke
^ The pinion gears
^ The pinion thrust washers
4. Install the left thrust washer. Assemble the plates as shown.
5. Install the left side gear.
6. Install the latching bracket assembly.
7. Install the governor assembly. The straight end of the latching bracket spring must be over and outside the governor assembly shaft.
8. Install the case halves together. Hold the side gear in the left side case half.

Notice: Refer to Fastener Notice in Service Precautions.

9. Install the differential case screws.
^ Tighten the differential case screws to 17 Nm (13 lb ft).
10. Install the ring gear and the differential side bearings.