Rear Axle Housing Cover and Gasket Replacement
Rear Axle Housing Cover and Gasket ReplacementRemoval Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Drain the rear axle.
3. Remove the rear axle housing cover bolts (1). Discard the rear axle housing cover bolts.
4. Remove the rear axle housing cover (2) from the axle housing.
4.1. Catch the oil in a drain pan.
4.2. Remove any gasket material from the rear axle housing and/or the rear axle housing cover.
Installation Procedure
1. Install the rear axle housing cover (2) and a new gasket.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not reuse the rear axle housing cover bolts.
2. Install the new rear axle housing cover bolts (1).
^ Tighten the rear axle housing cover bolts in a crosswise pattern to 40 Nm (30 lb ft).
3. Fill the rear axle. Use the proper fluid.
4. Lower the vehicle.