C0690

DTC C0690





Circuit Description
The Electronic Suspension Control (ESC) module provides a common low reference for all four of the suspension damper solenoids. The ESC module internally monitors the return voltage on the low reference circuit for a voltage out of range condition.

Conditions for Running the DTC
Continuously with the ignition on.

Conditions for Setting the DTC
The ESC module internally senses a low reference voltage out of range condition.

Action Taken When the DTC Sets
^ Disable all suspension damper solenoid outputs.
^ The SERVICE RIDE CONTROL message will be displayed.
^ Stores a DTC C0690 in the ESC module memory.

Conditions for Clearing the DTC
^ The ESC module senses the correct voltage on the low reference circuit upon the next ignition cycle.
^ Using a scan tool.
^ A history DTC will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.

Diagnostic Aids

Important: Ignition cycle counting is used by the ESC module to detect faults in the system. The objective is to eliminate false/intermittent codes while maintaining an acceptable level of system performance. The operation of the ignition cycle counting requires that a fault condition be present for four consecutive ignition cycles before it will set the fault code and display the "SERVICE RIDE CONTROL" message. If a fault code is present (without a fault being current), the system will go into one or more degraded modes without displaying a message. Resetting the ignition cycle counter is done by clearing codes with a scan tool. Clearing codes will override ignition cycle counting for one ignition cycle. Therefore, a fault condition will set the fault code immediately if it occurs on the first ignition cycle after the codes are cleared. Most occurrences of this DTC are caused by connector C450 not full seated, backed out or has a bent terminal.

The following conditions may cause a malfunction to occur:
^ An open in all four low reference circuits of the suspension damper solenoids.
^ An open in the solenoid ground circuit at the ESC module.
^ An open in G410 or SP410.
^ An open in G304 or G305.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. Tests whether the condition has been corrected or identified as specified in the supporting text.
3. Tests all 4 low reference circuits of the suspension damper solenoids for an open.
4. Tests all 4 control circuits of the suspension damper solenoids for an open.
5. Tests the solenoid ground circuit at the ESC module, should be less than 0.5 ohm.
7. Clear DTCs and checks to see if DTC will reset.