P1571

DTC C0298 or P1571





Test 1-9





Test 10-12

Circuit Description
C0298
The Powertrain Control Module (PCM) sends a state of health message to the EBCM via class 2 serial data communications

P1571
The EBCM requests desired engine torque from the PCM via the requested torque signal circuit.

Conditions for Running the DTC
C0298
The ignition is ON.

P1571
^ The ignition is ON.
^ The engine is running at a speed greater than 500 RPM for 5-20 seconds.
^ The EBCM has not set any current TCS related DTCs.

Conditions for Setting the DTC
C0298
The EBCM receives a state of health message informing the EBCM that the PCM has lost the ability to perform traction control.

P1571
The PCM receives an invalid requested torque signal for 3 seconds.

Action Taken When the DTC Sets
C0298
If equipped, the following actions may occur:
^ The EBCM disables the TCS/VSES.
^ The traction off indicator turns ON.
^ The message center displays the SERVICE STABILITY SYSTEM message.

P1571
^ The PCM sends a state of health message to the EBCM informing the EBCM that the PCM has lost the ability to perform traction control.
^ The EBCM sets DTC C0298 as a current DTC for as long as the malfunction is present.

Conditions for Clearing the DTC
C0298
The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.

P1571
^ The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.
^ A history DTC clears automatically after 40 consecutive warm-up cycles without a PCM detected failure.

Diagnostic Aids
C0298
A requested torque signal malfunction is only one possible cause for the PCM to lose the ability to perform traction control. DTC C0298 may set due to engine overheating, throttle actuator control failure, loss of ignition timing control by the PCM, etc. If DTC P1571 has not set, refer to Diagnostic System Check - Engine Controls in order to identify other possible causes of DTC C0298.

P1571
Thoroughly inspect connections or circuitry that may cause an intermittent malfunction.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
4. This step tests for voltage supplied to the EBCM from the PCM.
5. This step verifies the EBCM is creating a requested torque signal with a valid Hz frequency.
6. This step verifies the EBCM is creating a requested torque signal with a valid duty cycle.
7. The EBCM may be damaged if the requested torque signal circuit is shorted to voltage.