Power Seat Control Module: Service and Repair
MEMORY SEAT CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the seat trim panel.
2. Remove the seal cushion.
3. Disconnect the harness connectors (2).
4. Remove the memory module retaining screws (1).
5. Slide the module out.
6. Remove the module from the vehicle.
INSTALLATION PROCEDURE
1. Slide the module in until seated.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the memory module retaining screws (1).
Tighten
Tighten the screws to 3 N.m (26 lb in).
3. Connect the harness connectors (2).
4. Install the seat cushion.
5. Install the seat trim panel.
6. It a new memory seat module is installed, the seat needs to be synchronized:
6.1. Operate the seat in all directions:
^ Front tilt
^ Rear tilt
^ Horizontal
^ Recline
6.2. If the seat stops part way due to programmed soft stop, release the switch and operate again in the same direction till the seat touches the mechanical stop
6.3. Repeat the above for all seat moving axes.