Tailgate Latch: Service and Repair

Latch Replacement - End Gate

Removal Procedure

1. Lower the endgate.




2. Loosen the handle bolts.
3. Raise the endgate.




4. Remove the handle bezel by prying gently on the upper retainer tabs.




5. Disengage the linkage rods (1).




6. Lower and support the endgate.
7. Remove the cables from the side panel cable retainer bolts.




8. Remove the bolt holding the latch assembly.




9. Disengage the linkage rod from the latch assembly.
10. Remove the latch assembly from the endgate.

Installation Procedure




1. Engage the linkage rod to the latch assembly.
2. Install the latch assembly to the vehicle.





Notice: Refer to Fastener Notice in Service Precautions.

3. Install the latch assembly bolts.

Tighten the bolts to 25 N.m (18 lb ft).




4. Connect the cables on each side of the endgate to the side panel cable retainer bolts.




5. Engage the linkage rods (1).
6. Raise the endgate.




7. Install the endgate handle bezel.




8. Tighten the handle bolts.

Tighten the bolts to 25 N.m (18 lb ft).