Lamp Control Module: Service and Repair

REMOVAL PROCEDURE




1. Remove the IP trim bezel.
2. Remove the head lamp switch/4WD shift button housing from the IP by pulling outwards.
The arrows in the graphic shows the locations of the retaining clips.
3. Disconnect all the electrical connectors.




4. Remove the electrical tape around the lamp module and discard.
5. Remove the lamp module from the connector by pulling outwards.

INSTALLATION PROCEDURE




1. Install the lamp module to the connector until fully seated.

IMPORTANT: Do not tape past the line where the cooling fins begin. Taping around the fins will result in the module overheating.

2. Install a new electrical tape around the module in order to secure the module to the IP wire harness.
3. Connect all the electrical connectors.




4. Install the head lamp switch/4WD shift button housing to the IP so that the retainers are fully seated.
5. Install the IP trim bezel.