Power Door Lock Switch Replacement - Rear

REMOVAL PROCEDURE




1. Remove the upper garnish molding.
2. Remove the D-Pillar molding.
3. Disconnect the electrical connectors.




4. Push on the tab (2) in order to remove the switch from the D-Pillar molding.
5. Insert a small screwdriver between the tab (1) in order to pry out the switch from the case.

INSTALLATION PROCEDURE




1. Install the switch into the case by pushing until the tab (1) locks into place.
2. Install the switch assembly into the D-Pillar molding.
3. Connect the electrical connectors.




4. Install the D-Pillar molding to vehicle.
5. Install the upper garnish molding to vehicle.