Pitman Arm: Service and Repair

Pitman Arm Replacement

Tools Required
^ J6632-01 Pitman Arm Puller
^ J29193 Steering Linkage Installer (12 mm)
^ J29194 Steering Linkage Installer (14 mm)
^ J29107-A Universal Pitman Arm Puller
^ J24319-B Universal Steering Linkage Puller

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine protection shield, if equipped.





3. Remove the relay rod nut (8) from the pitman arm ball stud (2). Do not reuse the nut.

Notice: Do not hammer on the pitman arm, pitman arm shaft or puller. Damage to the pitman arm or steering gear may result.





4. Use the J24319-B in order to remove the relay rod from the pitman arm ball stud.
5. Remove the power steering gear.
Mark the pitman arm and the pitman shaft in order to ensure the proper alignment at assembly.
6. Remove the pitman arm nut.





7. Use the J29107-A or J6632-01 in order to remove the pitman arm from the steering gear pitman shaft.
8. Inspect the ball stud threads for damage.
9. Inspect the ball stud seals for excessive wear.
10. Clean the threads on the ball stud.

Installation Procedure
1. Install the pitman arm on the pitman shaft.
2. Align the marks made at the removal on the pitman arm and the pitman arm shaft.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install a new pitman arm nut.
Tighten the pitman arm nut to 250 Nm (184 ft. lbs.).
4. Install the power steering gear.
5. Install the relay rod (9) to the pitman arm ball stud.
6. Ensure the seal is on the stud.





7. Install the J29193 or the J29194.
Tighten the J29193 or the J29194 to 54 Nm (40 ft. lbs.) in order to seat the tapers.
8. Remove the J29193 or the J29194.
9. Install the new relay rod prevailing torque nut.
Tighten the new prevailing torque nut to 62 Nm (46 ft. lbs.).
10. Install the engine protection shield, if equipped.
11. Lower the vehicle.
12. Check the wheel alignment.