Power Steering Pump Replacement
Power Steering Pump ReplacementRemoval Procedure
1. Remove the power steering pulley.
2. Place a drain pan under the pump.
3. Remove the hose guide bracket from the front of the pump.
4. For vehicles with variable effort steering, disconnect the electrical connector.
5. Remove the hoses from the pump.
6. Remove the lower intermediate shaft from the steering gear.
7. Remove the bolt retaining the rear bracket to the engine.
8. Remove the bolts from the front of the pump.
9. Remove the pump from the vehicle.
10. Remove the bracket (3) from the rear of the pump (1).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the bracket (3) to the rear of the pump (1).
Tighten the rear bracket retaining nuts to 50 Nm (37 ft. lbs.).
2. Install the pump.
3. Install the hose guide bracket bolt to the pump.
4. Install the bolt retaining the rear bracket to the engine.
5. Install the bolts to the front of the pump.
Tighten the bolts to 50 Nm (37 ft. lbs.).
6. For vehicles with variable effort steering connect the electrical connector.
7. Install the hoses to the pump.
Tighten the nut to 28 Nm (20 ft. lbs.).
8. Install the intermediate shaft.
9. Install the power steering pulley.
10. Fill and bleed the power steering system.