Steering Damper: Service and Repair

Steering Damper Replacement

Tools Required
^ J24319-B Universal Steering Linkage Puller
^ J29193 Steering Linkage Installer-12 mm

Removal Procedure
1. Raise the vehicle. Support the vehicle with safety stands. Refer to Vehicle Lifting.
2. Remove the engine protection shield, if equipped.

Important: Do not reuse the nut.





3. Remove the steering damper (2) ball stud nut (1).





4. Remove the steering damper ball stud from the relay rod using the J24319-B.

Important: Do not reuse the nut.





5. Remove the steering damper mounting bolt (5) and the nut (6).
6. Remove the steering damper (4) from the vehicle.
7. Inspect the following parts:
^ The steering damper for leaks and damage
^ The mounting bolts and the nuts for damage or corrosion

Installation Procedure





1. Install the steering damper (4).
2. Install the mounting bolt (5) and a new prevailing torque nut (6).
3. Install the steering damper ball stud (2) to the relay rod (3).

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the J29193.
5. Tighten the steering linkage installer in order to seat the ball stud in the relay rod.
Tighten the installer to 54 Nm (40 ft. lbs.).
6. Remove the J29193.
7. Install the prevailing torque nuts.
Tighten the mounting nut to 40 Nm (30 ft. lbs.).
Tighten the ball stud nut to 62 Nm (46 ft. lbs.).
8. Install the engine protection shield, if equipped.
9. Lower the vehicle.