Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Intake
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT - BANK 1 (RIGHT) INTAKEREMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the camshaft position (CMP) sensor electrical connector.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
INSTALLATION PROCEDURE
1. Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the CMP sensor bolt.
Tighten
Tighten the CMP sensor bolt to 10 N.m (89 lb in).
3. Install the CMP sensor electrical connector.