Pedal Positioning Switch: Service and Repair
SWITCH REPLACEMENT - BRAKE AND ACCELERATOR PEDAL ADJUSTERREMOVAL PROCEDURE
CAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
2. Disconnect the adjuster pedal switch connector at the base of the steering column.
3. Remove the wire harness straps from the wire harness assembly.
4. Remove the adjuster pedal switch lead from the wire harness assembly.
5. Remove the 2 pan head tapping screws (2) from the lower trim cover (1).
6. Remove the lower trim cover (2).
7. Remove the adjuster pedal switch assembly (2) from the lower trim cover (1).
8. Remove the TORX head screw (2) from the upper trim cover (1).
9. Remove the upper trim cover (1).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the upper trim cover (1) and secure by using the TORX(R) head screw (2).
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
2. Install the adjuster pedal switch assembly (2) into the lower trim cover (1).
3. Install the lower trim cover (1).
4. Install the 2 pan head tapping screws (2) into the lower trim cover (1).
Tighten
Tighten the screws to 3.5 N.m (31 lb in).
5. Route the adjuster pedal switch lead into the wire harness assembly.
6. Install the wire harness straps onto the wire harness assembly.
7. Connect the adjuster pedal switch connector at the base of the steering column.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.