Side
INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENTREMOVAL PROCEDURE
CAUTION:
- Do not strike or jolt the inflatable restraint side impact sensor (515). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
- Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or SIR Disabling and Enabling Zone 6.
2. Move the seat to the full forward position.
3. Remove the center pillar trim panel.
4. Remove the connector position assurance (CPA) (1) from the harness connector (2) to the inflatable restraint side impact sensor (SIS).
5. Disconnect the harness connector (2) from the SIS (3).
6. Remove the 515 mounting fasteners (2).
7. Remove the 513 (1) from the center pillar.
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the 513 (1) to the center pillar.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the 513 mounting fasteners (2).
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
4. Install the harness connector (2) to the 313 (3).
5. Install the CPA (1) to the 313 harness connector (2).
6. Install the center pillar trim.
7. Move the seat to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or SIR Disabling and Enabling Zone 6.