Blower Motor Replacement - Auxiliary
BLOWER MOTOR REPLACEMENT - AUXILIARYREMOVAL PROCEDURE
1. Remove the left body side trim access panel.
2. Disconnect the blower motor electrical connector.
3. Remove the blower motor screws from the HVAC module.
4. Remove the blower motor from the HVAC module.
INSTALLATION PROCEDURE
1. Install the blower motor to the HVAC module.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the blower motor screws.
Tighten
Tighten the screws to 1 N.m (9 lb in).
3. Connect the blower motor electrical connector.
4. install the left body side trim access panel.