Blower Motor Switch - Auxiliary (Front)

BLOWER MOTOR SWITCH REPLACEMENT - AUXILIARY (FRONT)

REMOVAL PROCEDURE




1. Remove the overhead console (1).

IMPORTANT: Gently pull downward at the front edge of the overhead console to disengage the fasteners.

2. Disconnect the blower motor switch electrical connector.
3. Remove the blower motor switch screws.
4. Remove the blower motor switch from the dome lamp housing.

INSTALLATION PROCEDURE
1. Install the blower motor switch to the dome lamp housing.
2. Install the blower motor switch screws.

Tighten the screws to 1 N.m (9 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the blower motor switch electrical connector.




4. Install the overhead console (1).