Steering Column Trim Covers
Steering Column Trim Covers ReplacementRemoval Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Air Bags and Seat Belts.
2. Remove the tilt lever.
3. Remove the steering column lock cylinder.
4. Disconnect the adjuster pedal switch connector which is located by the switch.
5. Remove the 2 pan head tapping screws (2) from the lower trim cover (1).
6. Remove the lower trim cover (2).
7. If necessary, remove the adjuster pedal switch assembly (2) from the lower trim cover (1).
8. Remove the TORX� head screw (2) from the upper trim cover (1).
9. Remove the upper trim cover (1).
Installation Procedure
1. Notice: Install the upper trim cover (1) and secure by using the TORX� head screw (2).
Tighten the screws to 1.5 Nm (13 inch lbs.).
2. If necessary, install the adjuster pedal switch assembly (2) into the lower trim cover (1).
3. Install the lower trim cover (1).
4. Install the 2 pan head tapping screws (2) into the lower trim cover (1).
Tighten the screws to 3.5 Nm (31 inch lbs.).
5. Connect the adjuster pedal switch connector.
6. Install the steering column lock cylinder.
7. Install the tilt lever.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Air Bags and Seat Belts.