Object Alarm Module Replacement

OBJECT ALARM MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left rear quarter trim panel.
2. Disconnect the electrical connector from the module.
3. Remove the module fasteners (1).
4. Remove the module (2).

INSTALLATION PROCEDURE




1. Install the module (2).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the fasteners (1).

Tighten the module fasteners (1) to 1.7 N.m (15 lb in).

3. Connect the electrical connector.
4. Install the left rear quarter trim panel.