Restraints - Pass. Seat Belt Lamp ON/After Remote Start
Bulletin No.: 06-09-40-002Date: July 13, 2006
TECHNICAL
Subject:
Passenger Safety Belt Reminder Light Remains On After Remote Start (Perform Appropriate Corrective Action Below))
Models:
2007 Cadillac Escalade, Escalade ESV, Escalade EXT
2007 Chevrolet Avalanche, Suburban, Tahoe
2007 GMC Yukon, Yukon XL, Yukon Denali, Yukon Denali XL
with Remote Start (RPO AP3)
Condition
Some customers may comment that the passenger safety belt reminder light remains on with the passenger seatbelt buckled after a remote start.
Cause
This condition may be caused by a software anomaly within the SDM.
Correction
��S:
It is important that you first identify the calibration number that is in the SDM. This can be done using the Tech 2(R) and requesting module ID. The calibration number will determine if the SDM calibration can be updated or if the SDM will need to be replaced before the new calibration can be installed. Use the table's shown to identify the proper corrective action that is required.
If the vehicle has one of the current production calibrations listed below, DO NOT replace the SDM and DO NOT reprogram. If a problem still exists, it is not caused by a calibration error. Use normal diagnostics to correct the condition.
The new calibrations are currently available in TIS version 6.0 (or later) or on TIS2WEB.
Warranty Information
For vehicles repaired under warranty, use only one of the labor operations shown.
Disclaimer