Rear Seat Number 2 Back Pivot Actuator Motor Replacement - Cushion

Rear Seat Number 2 Back Pivot Actuator Motor Replacement - Cushion

Removal Procedure

1. Remove the seat cushion frame.




2. Disconnect the drive cables from the horizontal motor (1).
3. Disconnect the electrical connector from the motor.
4. Remove the motor.

Installation Procedure




1. Install the horizontal seat motor (1) to the frame.

Notice: Refer to Fastener Notice.

2. Install the horizontal seat motor screws.

Tighten the screws to 10 N.m (88 lb in).

3. Install the cables into the motor.
4. Connect the electrical connector to the seat motor.
5. Install the seat cushion frame.
6. Calibrate the seat. Refer to Power Folding Seat Calibration.