Mode Actuator Replacement

Mode Actuator Replacement

Removal Procedure

1. Remove the instrument panel (I/P) carrier.




2. Disconnect the mode actuator electrical connector.




3. Remove the mode actuator screws.
4. Remove the mode actuator.

Installation Procedure




1. If replacing the mode actuator, transfer the lever from the old actuator to the new actuator.
2. Install the mode actuator.

Notice: Refer to Fastener Notice.

3. Install the mode actuator screws.

Tighten the screws to 1 N.m (9 lb in).




4. Connect the electrical connector to the actuator.
5. Install the I/P carrier.