Air Inlet Assembly Replacement (Right Hand Drive)

Air Inlet Assembly Replacement (Right Hand Drive)

Removal Procedure

1. Remove the instrument panel (I/P) compartment.
2. Remove the left insulator panel.




3. Remove the upper air inlet assembly bolts (1) from the I/P carrier.




4. Remove the lower left air inlet assembly bolt from I/P carrier (1).
5. Slide the assembly to the left and then lower.




6. Disconnect the air inlet assembly electrical connector (1).




7. Rotate the air inlet assembly (1) and remove.

Installation Procedure




1. Install the air inlet assembly (1) to the locator pin.




2. Connect the air inlet assembly electrical connector (1).






Notice: Refer to Fastener Notice.

3. Install the upper air inlet assembly bolts to I/P carrier (1).

Tighten the bolt to 9 N.m (80 lb in).




4. Install the lower right air inlet assembly bolt to I/P carrier (1).

Tighten the bolt to 9 N.m (80 lb in).

5. Install the I/P compartment.
6. Install the left insulator panel.