Liftgate Wiper Motor Replacement

Liftgate Wiper Motor Replacement

Removal Procedure

1. Remove the rear wiper arm.




2. Remove the interior liftgate trim panel.
3. Disconnect the fluid line from the wiper motor.
4. Disconnect the wire connector from the wiper motor.
5. Remove the wiper motor attaching bolts.
6. Pull the wiper motor through the shaft grommet.

Installation Procedure




1. Lubricate the wiper motor shaft with windshield washer fluid. Push the wiper motor shaft through the grommet.
2. Apply thread lock to the wiper motor attaching bolts.

Notice: Refer to Fastener Notice.

3. Install the wiper motor attaching bolts.

Tighten the bolts to 7 N.m (62 lb in).

4. Connect the wire connector to the wiper motor.
5. Connect the fluid line to the wiper motor.
6. Install the interior liftgate trim panel.
7. Install the rear wiper arm.