Sunroof Exterior Trim Cover Replacement (Rear)
Sunroof Exterior Trim Cover Replacement (Rear)
Tools Required
J 25070 Heat Gun
Removal Procedure
1. Open the liftgate.
2. Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement.
3. Remove the navigation antenna.
4. Remove the rear venting window.
5. Remove the screws that retain the side rear trim cover (1) to the frame.
6. Use J 25070 to heat the trim cover in order to release the double-sided foam tape.
7. Use a medium-sized prying tool to release the trim cover from the sunroof frame. Lift upward on the rear edge of the trim cover and pull rearward in order to remove the rear trim cover (1) from the rear edges of the side rear trim covers (2, 6).
8. Remove the trim cover from the sunroof frame.
9. Use 3M(R) General Purpose Adhesive Cleaner P/N 08984, or equivalent, to remove all traces of the adhesive foam tape (1) from the sunroof frame.
10. Use 3M(R) Automotive Adhesion Promoter Wipes P/N 06396, or equivalent, to thoroughly wipe down the sunroof frame where you will apply the trim cover.
Installation Procedure
Important: The ambient temperature of the building should be above 16°C (60°F) to ensure correct adhesion of the trim cover panel.
1. Using J 25070 warm the sunroof frame to 21°C (70°F).
Important: Pull the backing from the trim cover tape just prior to installation. Do NOT touch the adhesive with your hands or allow the tape to come into contact with dirt or foreign matter. Do NOT let the tape come into contact with the sunroof frame before you align the trim cover to the screw inserts.
2. Carefully align the rear cover tabs (6) under the rear side trim covers (4, 5).
3. Lower the trim cover to the frame.
4. Use moderate hand pressure to ensure proper adhesion of the double-sided foam tape.
Notice: Refer to Fastener Notice.
5. Install the rear trim screws.
Tighten the rear trim screws to 5 N.m (44 lb in).
6. Install the rear venting window.
7. Install the digital radio
8. Install the headliner.
9. Close the liftgate.