Power Steering Reservoir Inlet Pipe/Hose Replacement

Power Steering Reservoir Inlet Pipe/Hose Replacement (LY7)

Removal Procedure

1. Remove the front air deflector.
2. Place drain pans under the vehicle as needed.
3. Remove as much fluid from the power steering reservoir as possible.




4. Disconnect the power steering reservoir inlet hose from the power steering cooler.




5. Remove the power steering reservoir inlet hose to frame retaining bolt.




6. Disconnect the power steering reservoir inlet hose from the power steering reservoir.
7. Remove the power steering reservoir inlet hose from the vehicle.

Installation Procedure

1. Position the power steering reservoir inlet hose to the vehicle.




2. Connect the power steering reservoir inlet hose to the power steering reservoir.





Notice: Refer to Fastener Notice.

3. Install the power steering reservoir inlet hose to frame retaining bolt.

Tighten the bolts to 10 N.m (88 lb in).




4. Connect the power steering reservoir inlet hose to the power steering cooler.
5. Clean any excess fluid from the vehicle.
6. Remove the drain pans from under the vehicle.
7. Install the front air deflector.
8. Bleed the power steering system.