Inclination Sensor Inoperative
Inclination Sensor Inoperative
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
Circuit/System Description
The inclination sensor detects changes in the angle of the vehicle while parked. B+ is supplied to the inclination sensor at all times and the body control module (BCM) arms the sensor using the armed signal circuit. If a change greater than 3 degrees for a 7 second period is detected, rear (auxiliary) body control module (RBCM) is informed via the inclination sensor signal circuit and the content theft alarm is sounded. The sensor recalibrates itself each time the vehicle is parked, which allows it to account for parking on steep grades without unintentional activation.
Reference Information
Schematic Reference
Theft Deterrent System Schematics (Theft Deterrent System Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Content Theft Deterrent (CTD) Description and Operation (Content Theft Deterrent (CTD) Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the inclination sensor.
2. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
• If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
3. Ignition OFF, disconnect the X7 harness connector at the BCM.
4. Ignition ON, test for less than 1 volt between the signal circuit terminal 15 and ground.
• If greater than the specified range, test the signal circuit for a short to ground.
5. Test for infinite resistance between the signal circuit terminal 15 and ground.
• If less than the specified value, test the signal circuit for a short to ground.
6. Test for less than 2 ohms of resistance between the signal circuit terminal 15 at the BCM and the signal circuit terminal 4 at the inclination sensor.
• If greater than the specified range, test the signal circuit for an open/high resistance.
7. Ignition OFF, disconnect the X1 harness connector at the RBCM.
8. Ignition ON, test for less than 1 volt between the signal circuit terminal B10 and ground.
• If greater than the specified range, test the signal circuit for a short to ground.
9. Test for infinite resistance between the signal circuit terminal B10 and ground.
• If less than the specified value, test the signal circuit for a short to ground.
10. Test for less than 2 ohms of resistance between the signal circuit terminal B at the RBCM and the signal circuit terminal 3 at the inclination sensor.
• If greater than the specified range, test the signal circuit for an open/high resistance.
11. If all circuits test normal, test or replace the inclination sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Theft Deterrent Vehicle Inclination Sensor Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for BCM and RBCM replacement, setup, and programming