Automatic Level Control Sensor and Bracket Replacement - Front

Automatic Level Control Sensor and Bracket Replacement - Front

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .




3. Disconnect the ride sensor link from the upper control arm ball stud.
4. Disconnect the ride sensor harness connector.




5. Loosen the ride sensor retaining nut.
6. Gently tap the ride sensor retaining stud in order to loosen the stud to fender connection.
7. Remove the ride sender from the vehicle.



Installation Procedure





1. Position the sensor to the vehicle.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the ride sensor retaining nut.

Tighten the nut to 9 N.m (80 lb in).





3. Connect the ride sensor link to the upper control arm ball stud.
4. Connect the ride sensor harness connector.
5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
6. Lower the vehicle.