B2610

DTC B2610

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptor
DTC B2610 00
- Passenger Compartment Dimming 1 Circuit




Diagnostic Fault Information






Circuit/System Description

The instrument panel (I/P) dimmer switch is used to increase and decrease the brightness of the interior backlighting components. The I/P dimmer switch provides a voltage signal that will increase as the brightness of the light are increased and decrease as the brightness of the lights are decreased. The body control module (BCM) provides a low reference signal and a B+ voltage reference to the I/P dimmer switch. When the I/P dimmer switch is placed in the desired position, the dimmed voltage setting is applied from the I/P dimmer switch through the I/P dimmer switch signal circuit to the BCM. The BCM interprets the signal and applies the dimmed voltage to the I/P lamps supply voltage circuit and the interior backlighting components dim to the requested level.


Conditions for Running the DTC

* Battery voltage must be between 9-16 volts.
* Park lamps ON.



Conditions for Setting the DTC

DTC B2610 00 will set when the BCM detects a short to ground in the LED backlight dimming control circuit.


Actions Taken When the DTC Sets

The BCM will not dim or illuminate any indicators supplied by the LED backlight dimming control circuit.


Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* You issue a scan tool CLEAR DTCs command.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.



Reference Information
Schematic Reference

Interior Lights Dimming Schematics (Interior Lights Dimming Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Interior Lighting Systems Description and Operation (Interior Lighting Systems Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)


Circuit/System Testing

1. With a scan tool clear the DTC.
2. Ignition OFF, disconnect the harness connectors at the components fed by the I/P lamps dimmer switch control circuit.
3. Operate the vehicle within the conditions for running the DTC and verify the DTC does not reset.

• If the DTC resets, test the LED backlight dimming control circuit for a short to ground. If the circuits test normal, replace the BCM.

4. Reconnect each component one at a time and verify that the DTC does not reset as current.

• If the DTC resets as current, test or replace the component responsible for setting the DTC.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Driver Information Display Switch Replacement (Service and Repair)
* Instrument Panel Lamp Dimmer Switch Replacement (Left Hand Drive) (Instrument Panel Lamp Dimmer Switch Replacement (Left Hand Drive))Instrument Panel Lamp Dimmer Switch Replacement (Right Hand Drive) (Instrument Panel Lamp Dimmer Switch Replacement (Right Hand Drive))
* Clock Replacement (Service and Repair)
* Control Module References (Programming and Relearning)for BCM, HVAC control module, or Radio replacement, setup, and programming