Sunroof Exterior Trim Cover Replacement (Rear)
Sunroof Exterior Trim Cover Replacement (Rear)
Tools Required
J 25070 Heat Gun
Removal Procedure
1. Open the liftgate.
2. It is only necessary to lower the headliner. Only do those step in headliner replacement that will lower the headliner enough to gain access the part. Refer to Headlining Trim Panel Replacement (Service and Repair) . Refer to Headlining Trim Panel Replacement (Service and Repair) .
3. Remove the navigation antenna. Refer to Digital Radio Antenna Replacement (Digital Radio Antenna Replacement) .
4. Remove the rear venting window. Refer to Sunroof Window Replacement (Front) (Service and Repair)Sunroof Window Replacement (Rear Vent) (Service and Repair)Sunroof Window Replacement (Center) (Service and Repair)Sunroof Window Replacement (Rear Stationary) (Service and Repair) .
5. Remove the screws that retain the side rear trim cover (1) to the frame.
6. Use J 25070 to heat the trim cover in order to release the double-sided foam tape.
7. Use a medium-sized prying tool to release the trim cover from the sunroof frame. Lift upward on the rear edge of the trim cover and pull rearward in order to remove the rear trim cover (1) from the rear edges of the side rear trim covers (2, 6).
8. Remove the trim cover from the sunroof frame.
9. Use 3M(R) General Purpose Adhesive Cleaner P/N 08984, or equivalent, to remove all traces of the adhesive foam tape (1) from the sunroof frame.
10. Use 3M(R) Automotive Adhesion Promoter Wipes P/N 06396, or equivalent, to thoroughly wipe down the sunroof frame where you will apply the trim cover.
Installation Procedure
Important: The ambient temperature of the building should be above 16°C (60°F) to ensure correct adhesion of the trim cover panel.
1. Using J 25070 warm the sunroof frame to 21°C (70°F).
Important: Pull the backing from the trim cover tape just prior to installation. Do NOT touch the adhesive with your hands or allow the tape to come into contact with dirt or foreign matter. Do NOT let the tape come into contact with the sunroof frame before you align the trim cover to the screw inserts.
2. Carefully align the rear cover tabs (6) under the rear side trim covers (4, 5).
3. Lower the trim cover to the frame.
4. Use moderate hand pressure to ensure proper adhesion of the double-sided foam tape.
Notice: Refer to Fastener Notice (Fastener Notice) .
5. Install the rear trim screws.
Tighten the rear trim screws to 5 N.m (44 lb in).
6. Install the rear venting window. Refer to Sunroof Window Replacement (Front) (Service and Repair)Sunroof Window Replacement (Rear Vent) (Service and Repair)Sunroof Window Replacement (Center) (Service and Repair)Sunroof Window Replacement (Rear Stationary) (Service and Repair) .
7. Install the digital radio. Refer to Digital Radio Antenna Replacement (Digital Radio Antenna Replacement) .
8. Install the headliner. Refer to Headlining Trim Panel Replacement (Service and Repair) .
9. Close the liftgate.