72. Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection

Tools Required

J 28410 Gasket Remover


Cleaning Procedure

1. Remove any old thread sealant, gasket material or sealant using J 28410.
2. Clean the oil pan and oil pan components in solvent.
3. Clean out debris from the bolt holes.
Caution: Refer to Safety Glasses Caution (Safety Glasses Warning) .
4. Dry the oil pan and oil pan components with compressed air.



Inspection Procedure





1. Inspect the exterior of the oil pan for the following conditions:

* Dents or damage to the exterior (1)
* Damage to the drain plug or drain plug hole (2)
* Damage to the transaxle brace mounting bosses (3)
* Damage to the transaxle mounting bosses (4)





2. Inspect the interior of the oil pan for the following conditions:

* Gouges or damage to the oil pan sealing surfaces (1)
* Damage to the oil pan scraper mounting holes (2)
* Damage to the bolt holes (3)

3. Repair or replace the oil pan and/or oil pan components as necessary.