Knock Sensor Replacement - Bank 2

Knock Sensor Replacement - Bank 2

Removal Procedure





1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
3. Remove the wiring harness heat shield from the oil level indicator tube to gain access.
4. Remove the knock sensor (KS) electrical connector.




5. Remove the KS bolt.
6. Remove the KS.



Installation Procedure





1. Install the KS.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the KS bolt.

Tighten the KS bolt to 23 N.m (17 lb ft).





3. Install the KS electrical connector.
4. Install the wiring harness heat shield to the oil level indicator tube .
5. Lower the vehicle.