B3883

DTC B3883

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptors
DTC B3883 02
- License Plate Lamp Circuit Short to Ground

DTC B3883 04
- License Plate Lamp Circuit Open

Diagnostic Fault Information





Circuit/System Description

The headlamp switch is supplied with ground at all times. When the headlamp switch is placed in either the park or low beam position, the BCM responds by applying battery voltage to the license plate lamp control circuit. This energizes the left and right license lamp.

Conditions for Running the DTC

Headlamp switch in park or low beam position.

Conditions for Setting the DTC

B3883 02

The BCM detects a short to ground on the license plate lamp control circuit.

B3883 04

The BCM detects an open /high resistance on the license plate lamp control circuit.

Action Taken When the DTC Sets

The license plate lamps will be inoperative.

Conditions for Clearing the DTC

* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.

Reference Information
Schematic Reference

Exterior Lights Schematics (Exterior Lights Schematics)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Exterior Lighting Systems Description and Operation (Exterior Lighting Systems)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, command the License Plate Lamps ON and OFF with a scan tool. The license plate lamps should turn ON and OFF when changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the X902 inline harness connector.
2. Test for less than 10 ohm between the ground circuit terminal 15 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit terminal 1 and ground.
4. Ignition ON, command the license plate lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the selected states.

• If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
• If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

5. If all circuits test normal, test or replace the E7L license plate lamp-left or E7R license plate lamp-right.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Liftgate Center Applique Replacement ()
* Control Module References (Programming and Relearning) for BCM replacement, programming and setup