P0575
DTC P0575
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0575
- Cruise Control Switch Signal Circuit
Circuit/System Description
When a cruise control function switch is activated, the body control module (BCM) detects a predetermined voltage. The BCM sends a serial data message to the engine control module (ECM) indicating the function that has been requested.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
* The ECM receives an invalid cruise control switch status serial data message from the BCM.
* This diagnostic runs continuously.
Actions Taken When the DTC Sets
DTC P0575 is a type C DTC.
Conditions for Clearing the DTC
DTC P0575 is a type C DTC.
Reference Information
Schematic Reference
Cruise Control Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector End Views By Name)
Description and Operation
Cruise Control Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Powertrain Diagnostic Trouble Code (DTC) Type Definitions)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
1. Verify that DTC B3794 is not set.
• If DTC is set, refer to DTC B3794 (B3794).
2. Road test the vehicle and attempt to engage cruise. Verify that cruise control engages properly and the DTC P0575 is not set.
• If DTC is set, replace the K9 BCM. Clear the DTC, road test the vehicle and attempt to engage cruise. If the DTC resets, replace the K20 ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for BCM or ECM replacement, setup, and programming