Rear Brake Hose Replacement

Rear Brake Hose Replacement

Removal Procedure
Warning: Refer to Brake Dust Warning Brake Dust Warning.

Warning: Refer to Brake Fluid Irritant Warning Brake Fluid Irritant Warning.


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement.




4. Disconnect the brake pipe fitting (1) from the rear brake hose.




5. Remove the rear brake hose retaining clip (1).




6. Remove the brake hose fitting bolt (1).

Note: Do not reuse the brake hose fitting gaskets.

7. Remove and discard the 2 brake hose fitting gaskets (2) from the brake hose fitting (3).

Installation Procedure





Note: Install new brake hose fitting gaskets.

1. Assemble the brake hose fitting bolt (1) with 2 new brake hose fitting gaskets (2) to the brake hose fitting (3).

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the brake hose assembly to the brake caliper and tighten the brake hose fitting bolt to 40 Nm (30 lb ft).




3. Position the brake hose to the bracket.
4. Install the rear brake hose retaining clip (1).




5. Install the brake pipe fitting (1) to the rear brake hose and tighten to 19 Nm (14 lb ft).
6. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement.
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure) Hydraulic Brake System Bleeding (Pressure).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.