7. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools
* EN 38416-2 - Crankshaft Button
* EN 41816 - Crankshaft Balancer Remover
* EN 46106 - Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools Special Tools.




1. Install the EN 46106 through the starter mounting hole.




2. Remove and discard the crankshaft balancer bolt.




3. Install the EN 38416-2 - button in the nose of the crankshaft.
4. Install the EN 41816 - remover in order to remove the crankshaft balancer.
5. Tighten the center bolt of the EN 41816 - remover in order to pull the crankshaft balancer off of the crankshaft.
6. Remove the EN 41816 - remover from the crankshaft balancer.




7. Remove the EN 46106 - tool.